This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

1

Gas Discussion / Re: Well G55 50 Round Magazine blowing up and other questions.

« on: February 10, 2012, 08:16:21 PM »

There is a spring with a guide rod that keeps the nozzle sprung back. The two ears that allow the rod the gow through but reatain the spring are either oversize or broke somehow allowing the spring to go past it.You can see the tabs/ears on the top right of the nozzle  in the pic.Same problem as described here http://forums.zeroin.co.uk/showthread.php?146189-Well-G55-(Mp5k)-feeding-issues

2

Gas Discussion / Re: Well G55 50 Round Magazine blowing up and other questions.

« on: February 10, 2012, 06:39:37 PM »

Well, i just received the two G55's i ordered from airsplat and they both broke within the first mag.........WTF?
Both of them seem to have the same problem. The return spring for the nozzle keeps jumping off of the ears on the nozzle. Seems like the nozzles are defective. Refund please

3

Gas Discussion / Re: Well G55 50 Round Magazine blowing up and other questions.

« on: February 08, 2012, 07:20:53 PM »

Is it the Maruzen 50rd mag or the Well 36rd mag that blows apart?
I thought it was the Maruzen that did it because they were not designed for higher pressure gas?

4

Retail Stores / Re: Need help finding a site!

« on: June 02, 2010, 04:07:05 PM »

Wasn't either one of those but thanks.

5

Retail Stores / Need help finding a site!

« on: June 02, 2010, 09:05:06 AM »

There was a retailer that was located in Japan(if I remember corectly) that mainly delt with custom guns.they had the guns categorized by they person(actual names of people) that made them.they were extremely high quality guns and a but pricey.it was a fairly graphical site and it was probably 5+ years since the last time I been to it so there is a good chance it's down now. I know it's not much to go off of but any and all help is welcome. I think it was a simple site address as well but I just can't remember it.

6

Gas Discussion / Hop Up Rubber For A HFC M190

« on: May 12, 2007, 05:55:57 AM »

I have a full metal/auto HFC M190. I need a hop up rubber and a few other parts. Where can i get them?