Print

[TheNose]

First off, This is the specific holster I'm looking at: http://www.airsoftgi.com/mobile/product_info.php?cPath=28_462&products_id=9791

I am concerned about bumping the mag release since it is exposed. So I was wondering if any of you guys had any experience with this holster, or any alternatives to offer. Thanks!

-thenose

[Old Dog]

Fom the look it appears to be the standard Serpa retention system, which works fine...

[TheNose]

I was just wondering, since the mag release button was facing out, if I would have any issues with bumping it against walls or cover and losing a mag

[XavierMace]

I doubt the mag release sits out past the grip and holster so it would have to be a pretty pin point hit.  Just banging it against the wall won't do it I don't think.  I would say you should be fine.

[Echo1031]

I hate when my mag falls out.

[TheNose]

Well who doesn't hate that? But anywho, bought the holster. It's very nice, but my kwa mark IV is a little tight. Anything I can do to help this? Or will it just break in over time?

[XavierMace]

Heat the holster up with a heat gun just enough to allow it to stretch a bit then insert and extract the gun while it's hot.